When a lightning strike hits, it erects a “protective wall” for the system.
发布时间:
2025-07-29
“When the power suddenly went out, our first reaction was that it was all over—but after a thorough inspection, we found that none of the system’s core components had sustained any damage; only the surge protector had been blown.” This is a genuine feedback statement from a customer.
Recently, we received a letter of appreciation from an oil depot project in the Ali Prefecture of Tibet. In the letter, the sender provided a detailed account of a thrilling incident that occurred during a recent thunderstorm.
The Tibet region sits at a high elevation, where vigorous atmospheric convection is common, leading to frequent intense convective rainfall—and recently, it has entered a peak season for thunderstorms. On that fateful day, sudden, heavy downpours accompanied by lightning struck the oil depot. At that very moment, the depot’s control system triggered an alarm, and the equipment immediately lost power. “My heart sank,” the project chief engineer wrote in his letter, “and my first thought was: ‘It’s over.’”
However, upon an urgent inspection, they were pleasantly surprised to find that the core components of the entire system remained completely undamaged. Tracing the wiring revealed that the signal surge protector had been punctured (see the figure below). It turned out that, at the very moment when the powerful surge voltage generated by lightning surged along the lines and invaded the system, the signal surge protector stepped in as a robust barrier, intercepting the surge voltage and sacrificing itself to protect the entire system.

This experience has further reinforced our conviction that the installation of surge protective devices (SPDs) is critical for project sites in high-altitude regions such as Tibet. The area is prone to intense convective rainfall, and the likelihood of severe weather events like lightning strikes is relatively high. In particular, instrumentation and valve installations located in outdoor operational areas are directly exposed to the natural environment and are therefore more vulnerable to surge voltages.
Based on our experience, we recommend installing SPDs at all project sites located at high altitudes or involving outdoor instrumentation and valve installation. Although they may go unnoticed in everyday operations, these devices serve as a critical safety barrier for the entire system during emergencies, helping to prevent more significant losses caused by equipment damage.

Signal Surge Protector
A surge protection device (SPD), hereafter referred to simply as SPD, is, in essence, a protective device specifically designed to safeguard electronic systems against transient overvoltages. It acts as a loyal guardian, constantly protecting electronic equipment and stepping in to defend it when transient overvoltages caused by lightning strikes, industrial interference, and other sources threaten to damage the system.
From a functional standpoint, it is truly a highly precise and rapid “protection expert.” When transient overvoltages propagate along signal lines and invade the system, the internal varistors can turn on within an ultra-short timescale of just a few nanoseconds, diverting the vast majority of the overvoltage to ground and thereby significantly reducing the threat it poses to equipment. Moreover, if the surge energy exceeds the device’s withstand threshold, the built-in thermal fuse will actively blow, sacrificing itself to block any subsequent surges and prevent further damage to the electronic system. As in the case experienced by the previous customer, during a severe thunderstorm, tens of thousands of volts of surge voltage invaded the system; the signal surge protector promptly activated its protection, ultimately leaving the core equipment completely undamaged while only sustaining damage itself.
SPDs are applicable in a wide range of scenarios. They protect critical equipment such as PLCs, DCSs, field instruments, and switches from overvoltage surges caused by lightning and other transient events; in security surveillance systems, they ensure the reliable operation of cameras, video recorders, and other devices; in process control applications, they provide safety and reliability for associated electronic control systems; and in smart grids, they safeguard the stable operation of power-related electronic equipment.
Choosing to install an SPD is, in essence, purchasing a “safety insurance” for your electronic systems. Although relatively inexpensive, it can, at critical moments, absorb the damage itself to safeguard more valuable electronic equipment, thereby preventing substantial financial losses and operational downtime caused by equipment failure. This approach—achieving robust protection at a modest cost—has made SPDs an indispensable component of control systems.
相关新闻